Join Jim LaPier for an in-depth discussion in this video Basic stairs, part of Learning Vectorworks (2014).
…After entering all our other building parameters and…structures, the last thing is our stair.…We're going to create a basic staircase to go from floor one to floor two.…Of course first,…we need to remove the area the stair will pass through in finish floor two.…I'm going to set scan two to visible, make sure finish floor two and…floor two are visible.…And finish Floor two as my active layer.…I'm also going to edit the layer and set the opacity to 25%.…
Click OK and zoom in here to the opening.…I'll use the 2D Polygon Tool to trace the opening.…Making sure to use the Zoom Snap loop to get the proper end points.…Now that my polygon is created,…I'm going to go to Layer Options > Active Only.…And I can see that now I have just the slab and the polygon for my opening.…If I look at these from a Right view,…I can see that the opening is well below the slab.…As the elevation for finished floor two is still set at zero.…
I'm going to go to my Modeling tab > Extrude,…I'm going to extrude the polygon 18 feet.…So that I'm sure that it passes through the finished floor two slab.…
- Setting up your workspace
- Working with classes and layers
- Entering values
- Working with geometry
- Creating 3D objects
- Modeling architecture
- Texturing and lighting
- Adding annotations
- Creating viewports
- Printing and sharing
Skill Level Appropriate for all
AutoCAD 2015 Essential Trainingwith Scott Onstott8h 35m Beginner
AutoCAD Architecture 2015 Essential Trainingwith Paul F. Aubin7h 27m Intermediate
1. The Interface
2. Environment Conventions
3. Basic Geometry
4. Basic 3D Shapes
5. Architectural 3D Modeling
8. Viewports and Sheets
9. Printing and Sharing
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.