Author
Released
4/28/2020Skill Level Intermediate
Duration
Views
- [Sam] My name is Sam Sharkawi and I welcome you to "SOLIDWORKS: "Design Study and Optimization" where we take a look at different design parameters and optimizing the part to minimize the weight and maximize the strength. We will take a look at standard solidworks and we'll also take a look at simulation and we will run and export reports out of this course. So please join me as we can take a look at decreasing design time and increasing efficiency.
Related Courses
-
SOLIDWORKS Simulation: Dynamic Analysis
with Tony Abbey2h 40m Intermediate -
SOLIDWORKS: Advanced Simulation
with Tony Abbey1h 52m Advanced -
SOLIDWORKS: Simulation for Finite Element Analysis
with Tony Abbey2h 29m Intermediate -
SOLIDWORKS: SimulationXpress
with Gabriel Corbett1h 14m Intermediate -
Learning SOLIDWORKS (2016)
with Gabriel Corbett1h 59m Beginner
-
Introduction
-
1. Setting Up Variables and Constraints
-
Setting up1m 15s
-
Introduction to sensors2m 52s
-
-
2. Setting Up and Running Design Studies
-
Running design study3m 54s
-
3. Design Studies Including Goals
-
Setting up goals5m 8s
-
Running and results1m 38s
-
-
4. Simulation Optimization
-
Simulation setup5m 49s
-
Simulation run and results3m 14s
-
-
Conclusion
-
Next steps39s
-
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.
CancelTake notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.
Share this video
Embed this video
Video: Optimize parts with design studies and simulation