From the course: SOLIDWORKS: 3D Printed Product Enclosure
Unlock the full course today
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Improve access to the ports with fillets and chamfers - SOLIDWORKS Tutorial
From the course: SOLIDWORKS: 3D Printed Product Enclosure
Improve access to the ports with fillets and chamfers
- [Instructor] The enclosure's now coming along really nicely, and we only have some fine details to finish up. If you look at the port cuts, they're quite angular at the top, and also because the ports are set back into the wall. It might be hard to plug things in to some of these, so we're going to angle the area around them to give them a bit more clearance. Open the top half part by clicking on it and pressing Open Part. And first thing, let's add some fillits around these sharp edges. Go to the Features tab, and click on Fillit. First, let's add a one millimeter fillit to these four edges here. Remember, if you click the wrong edge or face, you can just click on it again to remove it. There should be four on the edge here. Press OK to add those, and then let's add a smaller one on the SD card here. Select the Fillit tool again, and this time let's make it 0.3. There's one edge there, and then one edge there.…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Contents
-
-
-
-
-
(Locked)
Add a lip using the Offset tool3m 35s
-
(Locked)
Use the Convert tool to add a corresponding lip6m 47s
-
(Locked)
Improve access to the ports with fillets and chamfers2m 53s
-
(Locked)
Create multiple vents using a linear pattern3m 27s
-
(Locked)
Customize your model with the Text tool4m 58s
-
(Locked)
Add artwork using DXF files3m 56s
-
(Locked)
-
-