From the course: SOLIDWORKS: Designing a Stirling Engine

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Finish off this section of the assembly with screws

Finish off this section of the assembly with screws - SOLIDWORKS Tutorial

From the course: SOLIDWORKS: Designing a Stirling Engine

Start my 1-month free trial

Finish off this section of the assembly with screws

“

- We've just added a load of new parts to the assembly, but we're still missing some fasteners. So we're going to add those screws in now. Firstly, we're going to attach the heater bracket onto the base, in the same way that we did for the flywheel bracket. You might remember that we edited the base part, and we added these screw holes. We're going to do the same thing now. Click on the base part, and then click Edit part which is this fourth option. Go to the Features tab and select the Hole Wizard. And we want to add a countersink hole which is this one. Should be ANSI Metric, Flathead Screw, Size M4, and the End Condition is Through All. For the Position tab, select this lower face, and then press normal two. Now we're looking up from below. Press it again, and now we're looking down from above. And we can use these holes that are already in the bracket clock to line up the new screw holes. If you hover over the edge…

Contents