Join Gabriel Corbett for an in-depth discussion in this video Create a face fillet using hold lines, part of SOLIDWORKS Tips & Tricks.
- In this video I'm going to be showing you…how to create a Face Fillet using Hold Lines.…Now before I get into that I do want point out…what a regular Constant Radius Fillet looks like.…Now you can see it here with this yellow cylinder…in this grey cylinder,…and the blue fillet between the two.…That's a Standard Constant Radius Fillet,…and you can see it's got a lot of material here in the back,…very little material in the front,…and very little material on the sides.…In contrast,…this green fillet here you can see,…has got very little material on the back,…quite a bit of material on the front…as well as on the sides.…
And that's what I'm going to be showing you how to create.…The first thing I want to do…is I want to create a couple of Split Lines.…So the first Split Line I'm gonna use is to cut…this blue cylinder here in half,…and then I'm gonna cut a Split Line…into this grey cylinder and we're gonna use…those two Split Lines as our Hold Lines for that fillet.…So let's go up here to the Front Plane,…click on that,…
Skill Level Appropriate for all
Modeling a Bicycle Frame with SOLIDWORKSwith Leon van den Heever42m 34s Intermediate
New This Week
Tips and Tricks 2016
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.