Join Tony Abbey for an in-depth discussion in this video Base motion example, part of SOLIDWORKS Simulation: Dynamic Analysis.
- In this video, we're going to look at…transient dynamic analysis but using in force base motion.…We're going to use a modal method.…We'll start off by using just a single mode and…then we'll repeat the exercise using six modes.…We'll open up the Solidworks file…which is called tray3_begin.…And again if you don't have Solidworks 2018 or later,…then you use the corresponding file…you'll find in the exercise folders.…After the file is open, we go to the study tray-lumped mass.…
This was a normal mode analysis.…We can see the 10 modes that were calculated…down in the feature tree.…So we can review these very quickly.…Here's mode one, mode two, mode three, mode four,…mode five, mode six, mode seven, mode eight,…mode nine, and mode ten.…Now, if we review the mass participation table,…we'll see what modes are likely…to play a key role in the base motion.…
Now, mode one has 86% of the contribution.…The other modes, mode two, mode six, play a small role.…The total contribution is 93%,…but it's pretty clear out of that,…
- Analysis of normal modes
- Modeling different types of masses
- Dynamic analysis
- Controlling transient analysis
- Analyzing motion of bases
- Analyzing frequency response
- Interpreting results of analysis
Skill Level Intermediate
SOLIDWORKS: Simulation for Finite Element Analysiswith Tony Abbey2h 29m Intermediate
SOLIDWORKS: Shell and Beam Modeling in FEAwith Tony Abbey1h 22m Intermediate
1. Normal Modes Analysis
2. Key Dynamic Analysis Concepts
3. Transient Analysis
4. Frequency Response (FR) Analysis
Next steps1m 8s
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.