Opening and rounding off the bottom opening

- [Voiceover] We're going to now take the moment and open up…the bottom of the cuff and round off the corners.…The first thing we need to do is…establish the width of this cuff…and the way we're going to do that is…take the Bracelet Guide here.…I'm going to copy it to the work layer,…so right click on work.…Copy objects to layer.…and now we can hide the original Bracelet Guide curve.…I'm going to switch now to the front view.…

Left click and hold on the square curve here,…and select the center rectangle.…We're going to draw from zero, so hit F4.…and we need to establish the width of the opening.…A standard opening for a slip-on cuff…is about 30 millimeters wide.…So, you could type in 30 and just give it…a little bit of height. Just like this.…As long as it intersects into both these curves right here,…and the next thing to do is to zoom into this corner here.…

We're going to draw a Line Tool,…right from this intersection and snap to the perp…of the opposing curve and we'll switch over…to this part of the model,…