Join Eric Wing for an in-depth discussion in this video Placing area reinforcing, part of Creating Concrete Buildings with Revit Structure.
…Suppose we wanted to add bars going each way in an entire slab.…We do that by adding area reinforcing.…The objective of this video is to add an entire area of reinforcing.…We'll go number 12.…Twelve inches on center each way.…So, to get started, let's go to our project browser.…Let's go to level 2 in our structural plans.…Let's get started by trying to select the slab.…This is a difficult task.…Even if you tab around a bunch of times, it's almost impossible to do right now.…
That's okay.…Go ahead and go to our section.…Zoom in and select your slab.…Once you have the slab selected, go ahead…and click on area in the reinforcement panel.…Now, let's go back to level 2.…In our draw panel, we're going to go ahead and click our pick lines button.…I'm going to go ahead and pick the center…point of the beam That's pretty…much where our slab is ended Once you have…four points picked, let's go ahead and click on…the trim extend in the corner on the modified panel…The last one right here, and hit escape Now, let's take a look at our properties.…
- Creating levels
- Creating a structural grid
- Adding single and multiple columns
- Laying foundations
- Creating perimeter framing and pan joists
- Placing concrete slabs
- Reinforcing with rebar
Skill Level Intermediate
1. Setting the Stage
4. Concrete Framing
5. Structural Slabs
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.