Learn how to make a corner guard family.
- [Narrator] To make a Corner Guard family,…I'm gonna start by adding the parameters…that I need for the family.…I'm gonna add some length parameters…for the thickness of the Corner Guard.…Make that a type-based parameter.…I'll add a width parameter…for the horizontal width of the wall protection.…Then I'm going to add an instance-based height parameter,…as well as an instance-based offset from floor parameter.…
Then I'll add a material parameter…so it can control the appearance of the Corner Guard.…For the type of parameter, I'll select material…and make sure it's grouping…under the materials and finishes.…Now I'll click okay.…Now I'm gonna add the reference planes…that I'll use to host geometry to.…On the create tab I'm gonna create a reference plane.…The placement point for my Corner Guard…is gonna be at the intersection…of these two reference planes.…As I work with Dynamo, I'm gonna assume that…this is the face of the corner of the wall,…as well as this, with the actual wall geometry…being in the top right quadrant here.…
- Working with room boundaries
- Creating wall protection, door signage, and corner guard Revit families
- Placing wall protection, door signage, and corner guard Revit families
- Resolving conflicts with family placement
- Accommodating inside and outside room boundaries
Skill Level Advanced
1. Working with Rooms
2. Line-Based Wall Protection
3. Door Signage
4. Corner Guards
Combine all three1m 15s
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.Cancel
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.