Join Eric Wing for an in-depth discussion in this video Placing rebar parallel to the face, part of Creating Concrete Buildings with Revit Structure.
…Adding your reinforcing bar parallel to face means…you will see the length of the bar.…For example, if you want to add a vertical bar that goes from the top…to the bottom of a wall, you would add it as parallel to the face.…That face being the section that you're actually looking at.…The purpose of this video is to select a foundation wall in section.…Click the rebar button, and select rebar to parallel, to face.…We will then use the bar shape double aught.…So, to get started.…
Let's go to the project browser.…Under structural plans let's go down to top footing.…In the top of footing, let's go ahead…and double click on our section marker right here.…Let's zoom in on our foundation wall.…To add rebar to a wall we need to select the actual wall.…Under the Reinforcement panel, go ahead and click Rebar.…They give us some information about the hooks.…We can look at that later.…Click OK.…Now, what's going to happen is, a rebar-shaped browser is going to show up.…Rebar-shaped double-ought, or double zero, is just a straight bar.…
- Creating levels
- Creating a structural grid
- Adding single and multiple columns
- Laying foundations
- Creating perimeter framing and pan joists
- Placing concrete slabs
- Reinforcing with rebar
Skill Level Intermediate
1. Setting the Stage
4. Concrete Framing
5. Structural Slabs
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.