Join Eric Wing for an in-depth discussion in this video Placing fabric reinforcing, part of Creating Concrete Buildings with Revit Structure.
…So to add welded wire mesh is pretty much the same function…as adding area reinforcing, only we generally always add this in plan.…The objective of this video is to add fabric reinforcing to a slab.…We will look at the wire type, the splice length, and spacing.…So to get started, let's go to the Project Browser.…Let's go up to the roof level.…Again, it's hard to select the slab, so what we can do is go to any section.…Select the roof level slab, now let's click on Fabric.…
In the Project Browser, let's go back to roof.…Now, let's go ahead and in the Draw panel, click our Pick Lines button.…Let's go ahead and pick, the perimeter.…We'll go with the outside.…Notice the first point we pick is going to be our major direction.…Let's clean these up.…In the Modify panel, let's click the Trim Extend to Corner.…Let's click here, and here.…Here and here.…Let's go here and all the way over here.…Let's make sure we get 'em all.…I'm going to click here and then here.…It temporarily pushes it past it but that's…okay, it'll come back in once we're done.…
- Creating levels
- Creating a structural grid
- Adding single and multiple columns
- Laying foundations
- Creating perimeter framing and pan joists
- Placing concrete slabs
- Reinforcing with rebar
Skill Level Intermediate
1. Setting the Stage
4. Concrete Framing
5. Structural Slabs
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.Cancel
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.