From the course: Revit 2019: Essential Training for MEP (Imperial)

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Creating conduit types

Creating conduit types - Revit MEP Tutorial

From the course: Revit 2019: Essential Training for MEP (Imperial)

Start my 1-month free trial

Creating conduit types

“

- [Instructor] I told you modeling conduit was easy, but let's look and see where we get all this conduit from and configure a new conduit type. Under Projects, let's go Open. I'm going to browse through my Electrical Project conduit types, then I'm going to hit Open. Under Power, let's go down to Level One - Callout One. Now I want to load a family. So let's go to the Insert tab, Let's go to Load Family. Let's go to Conduit, go to Fittings, EMT. Boy look at all these fittings. I want to going to grab Conduit Elbow - Set Screw - Die Cast Zinc. Click Open. Now I want to draw a conduit off to this side of the panel, so select your panel, right-click on that icon, and Draw Conduit from Face. It's fine where it is, so I'll just click on Finish Connection. Let's knock this down a little bit. Let's just make this two inches. I'll come down to the wall here, pick a point. Now I'm just going to hit escape a couple times. Go ahead and select this piece of conduit, click Edit Type, this time…

Contents