From the course: Revit 2019: Essential Training for MEP (Imperial)
Unlock the full course today
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Adding air terminals - Revit MEP Tutorial
From the course: Revit 2019: Essential Training for MEP (Imperial)
Adding air terminals
- [Instructor] Adding an air terminal is very similar to adding a light, with one exception. We host lights to ceilings. Well, why not? If the architect moves the ceiling, our light moves with it. No problem. An air terminal would do the same thing. This is actually not the best workflow. The problem is, a light has nothing physically hooked to it. If it moves up a foot or two, no problem. An air terminal, however, has a duct hooked to it. If the air terminal moves up to the point where Revit can't make the duct connection, you'll get errors all over the place. So, let's do this. We're going to add an air terminal, but then we'll establish what the ceiling height is before we place the terminal. Then we'll change the CFM that the terminal is responsible for. To get going, let's go to our HVAC, Ceiling Plans, 1 - Ceiling Mech. Let's zoom in on this area right here. Like I just said, we're going to put in an air terminal, but we don't know what that ceiling height is. If we go to the…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Contents
-
-
-
-
-
Starting a mechanical project3m
-
(Locked)
Adding mechanical equipment1m 54s
-
(Locked)
Adding air terminals3m 28s
-
(Locked)
Adding supply duct3m 4s
-
(Locked)
Adding return duct3m 28s
-
(Locked)
Adding duct accessories and fittings2m 5s
-
(Locked)
Sizing duct2m 30s
-
(Locked)
Tagging duct5m 37s
-
(Locked)
Adding zones and heating and cooling loads4m 11s
-
(Locked)
Challenge: Mechanical24s
-
(Locked)
Solution: Mechanical4m 46s
-
-
-
-
-
-