Join Lazaro Diaz for an in-depth discussion in this video Understanding and configuring default routes, part of Advanced Cisco Routing: RIPv2, EIGRP, and OSPF.
- All right, so we can see that we can ping…our Gateway, but we just can't get across.…And we're not going to because we have…no routing set up.…Now the first part of routing that we're going…to set up is something called a default route.…Now let's explain something about default route…before we get into it.…Default route can only be configured…on the end routers, on the stub routers.…I'm going to point to them.…This is going to be router one,…and this is going to be router three…because that's the only way in and out…of the network.…
So this is the only place you can put them.…Now when we pinged we got an unreachable.…Let's see when we configure a default static route…on router one what happens.…So let's go there.…All right, so now we are in router one.…We're in privilege mode, so we need to go…to config t to take us to global configuration.…This is where we actually create the default route.…So we're going to say ip route…0.0.0.0 0.0.0.0 exit interface,…s0/0/0, enter.…
What this does the zeros mean match exactly.…
- Configuring static and default routes
- Understanding dynamic routing
- Issuing verification commands
- Comparing RIPng and RIPv2
- Using RIP timers
- Configuring an EIGRP feasible successor route
- Exploring EIGRP options
- Introducing the OSPF process ID
- Exploring wildcard masking
Skill Level Advanced
1. Configuring Routing on a Cisco Router
2. The Routing Information Protocol (RIP)
3. The Enhanced Interior Gateway Routing Protocol (EIGRP)
4. The Open Shortest Path First (OSPF) Routing Protocol
Wrapping up3m 5s
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.