Taking off from the previous video, Todd Lammle shows the steps for adding IPv6 routing to a Cisco router once it has been configured with IPv6 addresses on the router interfaces. Todd provides the steps for using both static and default routing on the three Cisco routers in the lab setup. He finishes by verifying the configurations and testing wtih the ping protocol. He then goes on to configure RIPng just to show you the simple manner you can run the RIPng protocol
- [Narrator] All right.…We're gonna run out to the corp router…and configure static routing…then we'll run out to San Francisco and LA…and do a default route which is easy.…I don't even need a figure for that one.…But with static routing,…you are well aware that we need a figure.…In this case here,…the corp router is connected to…subnets one, six, seven and eight.…San Francisco's connected to subnet two on the far end…and LA to subnet three.…So the corp router needs a static route to subnet two…and to subnet three, so just two static routes…because I'm not using the loop backs by the way,…and then the LA and San Francisco routers…just need a default route.…
So let's run out to corp and put in a route to subnet two…and a route to subnet three.…So here at my corp, we'll say ipv6 route…and we'll say 2001:db8:3c4d…and I wanna go to colon two…so ipv6 route destination network…and I'm putting in a network ID…so my host IDs are all zero here.…And I'm gonna use the exit interface, right, so ipv6 route.…
I could use the next hop,…
For more information on the CCENT exam, visit Cisco's website.
- Overview of internetworking
- The TCP/IP networking model
- Easy subnetting
- Managing Cisco IOS
- Managing Cisco networks and devices
- IP routing
- Layer 2 switching
- VLANs and InterVLAN routing
- Network address translation
Skill Level Intermediate
Learning Cisco CLI Router Configurationwith Denise Allen-Hoyt1h 38m Intermediate
Internetworking devices4m 20s
3. Introduction to TCP/IP
4. Easy Subnetting
5. VLSM, Summarization, and Troubleshooting TCP/IP
6. Cisco Internetworking Operating System (IOS)
7. Managing a Cisco Internetwork
8. IP Routing
9. Layer 2 Switching
10. VLANs and InterVLAN Routing (IVR)
12. Network Address Translation (NAT)
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.Cancel
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.