In this video, Todd Lammle shows you the all-so-important configurations of setting an interface with an IP address and enabling the interface. In addition, he explores how to set your console, aux, and VTY port passwords, used for both in-band and out-of-band configuration. It's important you have the foundation of CLI command down before moving onto the hands-on videos coming up next.
- [Narrator] We're going to go ahead and continue on…and configure our interfaces and our passwords.…But before you can do that,…you have to understand your prompts.…So, first plug-in, I'm going to be in user mode.…I type the command enable, and end up in privileged mode.…To configure the device, you type "configure terminal",…with our router switch.…Now, I usually just type "config t".…I've been doing that for 20 years, config t.…This takes me to something called global config.…Now, I can type end or control z and get back…to privileged mode, but from here I can type anything…I want, like interface e zero,…which would take me to the config if prompt.…
Tell me I'm at an interface.…Or configure an interface.…I can also create logical interfaces,…and I would say config sub if,…and we'll see those in later configs.…Now, if I was configuring a line, like my console,…my prompt would say config line.…And if I was configuring a routing protocol,…such as RIP or OSPF, it would say config router.…To configure the name of a hoster switch, very simple.…
For more information on the CCENT exam, visit Cisco's website.
- Overview of internetworking
- The TCP/IP networking model
- Easy subnetting
- Managing Cisco IOS
- Managing Cisco networks and devices
- IP routing
- Layer 2 switching
- VLANs and InterVLAN routing
- Network address translation
Skill Level Intermediate
Internetworking devices4m 20s
3. Introduction to TCP/IP
4. Easy Subnetting
5. VLSM, Summarization, and Troubleshooting TCP/IP
6. Cisco Internetworking Operating System (IOS)
7. Managing a Cisco Internetwork
8. IP Routing
9. Layer 2 Switching
10. VLANs and InterVLAN Routing (IVR)
12. Network Address Translation (NAT)
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.Cancel
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.