Learn how to configure IPv6 addresses on a Cisco router interface and allow a Cisco router to communicate using an IPv6 address. We start with the global configuration command "IPv6 unicast-routing" to enable IPv6 on the router and then configure IPv6 addresses on each router interface using subnets for each link. We then verify the configuration with the show IPv6 interface brief and the show ip interface fastethernet 0/0 command, and finish with the output of the show running-config command.
- [Narrator] Alright, let's run out to the Corp router…and put some IPv6 addresses on the interfaces.…We have four interfaces on the Corp router.…S011 going to San Francisco.…S001 and S010 going to L.A.…And then we have our FA00…on the land of our Corp router.…Let's run out there and configure them…and just be aware that I've already configured…the San Francisco and L.A. routers…with their respective IPv6 addresses.…So also, I wanna mention one more thing…I'm on subnet six between Corporate and San Francisco…subnet seven and eight between Corp and L.A.…
and subnet one on the Corp LAN.…Alright, the first thing we wanna do…is enable IPv6 routing.…If I was doing…IP Version 4 it's just…IP routing.…That's enabled by default.…But to do IPv6…it's IPv6 what?…Unicast-routing.…Now I can go out to my interfaces…say IPv6 address…and I'm gonna only have to type this in once 'cause…I know it seems cumbersome to you guys…but once you get used to it, it's really not that bad.…
Alright subnet.…So there's my first four fields of 16 bits each.…
For more information on the CCENT exam, visit Cisco's website.
- Overview of internetworking
- The TCP/IP networking model
- Easy subnetting
- Managing Cisco IOS
- Managing Cisco networks and devices
- IP routing
- Layer 2 switching
- VLANs and InterVLAN routing
- Network address translation
Skill Level Intermediate
Internetworking devices4m 20s
3. Introduction to TCP/IP
4. Easy Subnetting
5. VLSM, Summarization, and Troubleshooting TCP/IP
6. Cisco Internetworking Operating System (IOS)
7. Managing a Cisco Internetwork
8. IP Routing
9. Layer 2 Switching
10. VLANs and InterVLAN Routing (IVR)
12. Network Address Translation (NAT)
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.