In this video, Todd Lammle steps through the basics of the Cisco command line interface, or CLI. In this lab, Todd explores setup mode, showing the most basic configuration possible. From there, he shows some of the basic prompts for navigating through the CLI. Learn about the differences between user and privileged modes on a Cisco router or switch.
- [Instructor] Let's go ahead and get started…with our configuration.…I'm going to start with the Corp router here.…I've erased the configuration and reloaded the router,…so it's back at factory default.…I'm plugged into the console,…let's go ahead and take a quick look.…Now the router again has been erased,…now, I would see the same thing here…if I was working on a switch,…I erased the switch and reload,…I'd end up at this set up mode.…This is a bad prompt to see on a, say,…you come to work on a Monday morning…and this is what your Corp router is doing or something,…because this means you have no configuration.…
So typically, you would say no to this,…but in this one instance of my life,…I'm going to say yes, and never again in my life.…Now, what I like to enter, basic management setup again…one time we're gonna do it.…Now, the thing it does say is it tells us,…hey, if you see something in brackets here,…in these square brackets, those are the defaults,…so you can just press enter.…So in this case it was asking a question.…
For more information on the CCENT exam, visit Cisco's website.
- Overview of internetworking
- The TCP/IP networking model
- Easy subnetting
- Managing Cisco IOS
- Managing Cisco networks and devices
- IP routing
- Layer 2 switching
- VLANs and InterVLAN routing
- Network address translation
Skill Level Intermediate
Internetworking devices4m 20s
3. Introduction to TCP/IP
4. Easy Subnetting
5. VLSM, Summarization, and Troubleshooting TCP/IP
6. Cisco Internetworking Operating System (IOS)
7. Managing a Cisco Internetwork
8. IP Routing
9. Layer 2 Switching
10. VLANs and InterVLAN Routing (IVR)
12. Network Address Translation (NAT)
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.