From the course: Meshmixer Essential Training
Unlock the full course today
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Importing your photo as a stencil into Meshmixer - Meshmixer Tutorial
From the course: Meshmixer Essential Training
Importing your photo as a stencil into Meshmixer
- [Instructor] This section is very easy. It's how to get your picture into Meshmixer to be used as a stencil. So no matter what model you have up here, you can go into Sculpt. Make sure the slider up here is on Surface. And underneath Stencils, you can just click on this plus icon. That will bring up a window. And it will usually go to the default Meshmixer install folder, but you can go anywhere you want and select your image. So this was my original, and this was my edited image that's absolutely square. So I'm going to select that and click Open. So now, inside of Stencils, we have a new stencil right here that we can click on and use. Now, the model isn't ready yet. In the next video, I'll talk about how to get a good result when using stencils by adding a little bit more detail to your model.
Contents
-
-
-
-
-
-
-
-
-
(Locked)
Introduction to the fun of 3D scanning34s
-
(Locked)
Downloading GIMP for photo editing1m 16s
-
(Locked)
Cropping and adjusting your photo in GIMP for use in Meshmixer4m 30s
-
(Locked)
Importing your photo as a stencil into Meshmixer59s
-
Preparing your mesh for best stencil results1m 54s
-
(Locked)
Applying the stencil: Stencil strength and inversing4m 39s
-
(Locked)