From the course: Audio Foundations: Compression and Dynamic Processing
Understanding threshold
From the course: Audio Foundations: Compression and Dynamic Processing
Understanding threshold
Compressors, like all dynamics processors, work by measuring the incoming signal's amplitude against a user- defined reaction point, where the compressor will begin to work. This reaction point is known as the compressor's threshold. Think back to our example of watching TV and turning down the volume at a commercial break. We all have a unique threshold of how loud is too loud and what will force us to grab the remote and turn down the volume. That volume level is our threshold, and is actually the most important component of any dynamic processor. In a compressor, a signal level above the threshold will cause the compressor to react, while a signal level below the threshold is left unaffected. The threshold's value is generally measured in the dBFS to match our DAW's metering; therefore, a value of 0 dBFS means that threshold is sitting at the digital clipping point and can go no higher. The Threshold level goes down as you dial it deeper into the negative numbers. For example, a threshold setting of -20 dBFS would cause the compressor to react to any signal whose amplitude is measured at over -20 dBFS up through 0 dBFS. Therefore, a signal of -10 dBFS could trigger a reaction in the compressor, while a signal of -25 dBFS would not. Now that we know what threshold is and how to read its values, how do we actually use it? Well, that depends on a number of other compression parameters, including ratio, which we will discuss in the next movie.
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Contents
-
-
-
-
Introducing compressors1m 45s
-
Understanding threshold1m 29s
-
(Locked)
Utilizing compression ratios3m
-
(Locked)
Understanding makeup gain and gain reduction3m 13s
-
(Locked)
Understanding attack and release2m 12s
-
(Locked)
Applying attack and release5m 22s
-
(Locked)
Demystifying compression controls: soft knee vs. hard knee2m 43s
-
Get in the Mix: Using compression to even out a vocal performance4m 55s
-
(Locked)
Get in the Mix: Using compression to add punch and sustain to drums4m 39s
-
(Locked)
Intelligently using compression presets3m 6s
-
(Locked)
Recording with compression: Why or why not?2m 53s
-
Recording with compression: How to do it3m 23s
-
-
-
-
-
-