From the course: Linux System Engineer: Network Bonding, IPv6, Routing, and Virtual Systems
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Viewing the routing table
From the course: Linux System Engineer: Network Bonding, IPv6, Routing, and Virtual Systems
Viewing the routing table
- [Instructor] To view your routing table, you could be logged in to either of your VMs. I've logged in to my rhhost2 VM. In a terminal, type in ip space route and hit Enter. Let's look at the different parts of this output. The left-hand column is the destination network address with subnet mask. The word default signifies the default gateway address where traffic is sent if there is no available route. The second section encompasses two words, dev and the name of the device of the network. This could be a physical or virtual network device. The third section also encompasses two words, proto followed by the protocol. The kernel protocol says that the kernel installed the route during auto-configuration. These protocols are defined in the /etc/iproute2/rt_protos file. If this section says proto static, it means the route was set by the administrator and overrides the dynamic routing. The next section determines the scope of the destination. The /etc/iproute2/rt_scopes file defines…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Download courses and learn on the go
Watch courses on your mobile device without an internet connection. Download courses using your iOS or Android LinkedIn Learning app.