This video explains how to troubleshoot your model if there is no watershed identified, and how to adjust parameters to produce a better result.
- Apart from the little hiccup we saw in the previous video…where we could not get InfraWorks to realize that a design…road was a design road even though it hadn't been drawn on,…there may be a few other things which could contribute to…your frustration when you are doing watershed analysis.…Let's have a look at one of them right now.…If you head over to Bookmarks and Watershed Troubleshooting,…you'll find this little green pin here so there we go.…
Now let's do exactly when we've been doing…for the past few videos.…Let's go to Create Watersheds and…just put a pin next to the one that's already there.…So we're going to create a watershed from a point.…We're going to start our analysis and…now when it has done uploading the data,…we're going to get an Error.…The Error says that your analysis request did not…complete successfully because the selected…point does not return a watershed.…
If, by any chance, you were doing this on a road and…you didn't have a properly successfully completed analysis,…then no cloud credits would be deducted from…
Released
1/22/2018- Hydrology terms and methods
- Analyzing a watershed
- Troubleshooting your model
- Modifying culverts
- Culvert reporting
- Adding a drainage network to a model
- Analyzing and inspecting elements of a drainage network
- Sizing a drainage network
Share this video
Embed this video
Video: Tips and tricks