In this video, learn to add culverts manually one at a time, for times where the watershed analysis does not identify a watershed for a portion of a road.
- [Narrator] Head on over to adding culverts B.…You'll see here that we have, if we zoom out a little bit,…we have two watersheds butting up against each other.…This is one that we did earlier.…This was the first watershed that we did.…If we zoom back to adding culverts B and…we hit escape so that the watershed isn't selected,…now we can add a culvert manually.…
What you do is you go to your drainage design button,…you hit the little pencil to design your drainage,…and we have an add culverts button.…That's what we're going to do so you see the cursor…change to a little cross-hair and we just click.…One side, double click to end.…It will generate the culvert for us.…It doesn't matter whether or not we had…a watershed there in the first place,…it would still generate a culvert for us.…
You'll see that the behavior is a little bit…different to what we saw previously.…The first thing that you'll see is it's put the culvert in…for us, there it is right down there.…Hit escape in order to come out of the tool.…Otherwise you'll still have the little cross-hairs and…
Released
1/22/2018- Hydrology terms and methods
- Analyzing a watershed
- Troubleshooting your model
- Modifying culverts
- Culvert reporting
- Adding a drainage network to a model
- Analyzing and inspecting elements of a drainage network
- Sizing a drainage network
Share this video
Embed this video
Video: Adding culverts to a road manually