- [Instructor] In this video we have…one more piece of logic to work out,…and that is the order of the points that we have…so that we have a consistent start point…for each panel that we're going to place.…Now if you you recall…one of the earlier videos in this chapter,…we talked about this issue.…And there we discussed what would happen…if you got the points out of sequence.…Now when we talked about it there,…I mentioned that the curtain panel that we had,…ideally we wanted to build it in a consistent fashion…where we always started at the lower left-hand corner…and went counter-clockwise.…
We don't want something like this,…where it zigzags on itself,…or something where it starts…at a completely different point and goes around…in a different location.…So it turns out that all of our points…are at least in the correct sequence…relative to one another,…in other words, sometimes they start here and go around,…sometimes they start here and go around,…sometimes they start here.…But they always go in the same direction.…
AuthorPaul F. Aubin
- Placing a single Revit Family
- Selecting elements with basic selection nodes
- Lists and lacing
- Renaming multiple project views
- Adaptive component requirements
- Selecting elements by family type
- Joining multiple lists into a single list
- Removing the unwanted points
- Reorganizing points
Skill Level Intermediate
1. Placing Component Families along a Path
2. Renaming Multiple Project Views
3. Placing Adaptive Component Families
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.Cancel
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.