- Let's turn on all the layers, type, "layon"…and you see that we need a disc break up here.…There's no sense in reinventing the wheel.…Let's go ahead and copy what we've already created…on the rear axle up here to the front axle.…Let's go back here, and navigate…so that we can focus on the rear axle.…Now let's turn off some of the layers that are in the way.…"layoff" Enter, we'll turn off the spokes both in 3D and 2D.…
I'll turn off the transmission, the belt, the sprockets,…controller, and that's probably good enough.…So I'll press Enter.…I'm going to reset the coordinate system back to World,…by typing, "ucs", Enter, Enter.…So now the x-y plane is on the ground, if you will.…Now let's Copy the rear axle, the disc break assembly here,…which includes the rotor, the hub, and the fasteners.…Plus, let's also copy the acorn nut…and the piece below, those two pieces,…as well as the corresponding two pieces below like that.…
Enter.…Now I'm going to specify the base point right here…at the center of the axle on the plan.…
Author
Released
11/11/2014- Creating layers for 3D modeling
- Extracting isolines
- Trimming and extending surfaces
- Extruding 2D curves into 3D surfaces
- Lofting cross sections
- Converting solids into surfaces
- Sculpting watertight surfaces into solids
- Sweeping and sculpting
- Revolving boundaries to create surfaces
- Welding objects together with Fillet Edge
- Rebuilding NURBS surfaces
- Offsetting a surface
Skill Level Intermediate
Duration
Views
Related Courses
-
Learning Autodesk Inventor
with John Helfen2h 50m Beginner -
AutoCAD 2013: 3D
with Scott Onstott2h 37m Beginner
-
Introduction
-
Welcome42s
-
-
1. Modeling a Bicycle Frame
-
Extracting isolines4m 10s
-
Drawing a profile6m 6s
-
Trimming surfaces4m 42s
-
Revolving profiles3m 8s
-
Lofting with the Path option2m 45s
-
2. Creating the Belt-Tensioning Mechanism
-
Extruding a region2m 32s
-
Modeling fasteners5m 30s
-
3. Building the Drivetrain Components
-
Using Booleans on 2D regions4m 35s
-
4. Modeling the Rear Brakes
-
5. Creating the Rear Wheel
-
Sweeping and sculpting6m 29s
-
6. Making the Power Components
-
Smoothing a mesh object4m 13s
-
Tilting up extruded objects4m 30s
-
7. Modeling the Front End
-
8. Creating the Handlebars
-
9. Making the Seat
-
Conclusion
-
Next steps15s
-
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.
CancelTake notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.
Share this video
Embed this video
Video: Copying components from the rear axle to the front axle