In this video, Zahraa provides an overview of power pins that are used on the Arduino board.
- [Instructor] These are the power pins.…They're usually located in the left side…of the Arduino board.…The first one is a voltage in.…V-in and sometimes labeled nine volts,…use this input voltage when using an external power source…as opposed to the five volt from the USB connection.…An example is when providing a voltage…from external source like a solar panel.…Note that different boards accept different input voltages…so always check the documentation.…
The five volts, this pin outputs…a regulated five volts from the regulator…on the board to provide a voltage to your circuit.…We'll use this pin in our examples later in the course.…Three V three provides an output of 3.3 volts,…and finally, the ground pins.…So when we build a circuit, it's important…to have a common ground with Arduino,…and here where we connected.…
- What's an Arduino?
- Creating an Arduino program
- Using the setup() and loop() functions
- Using the pinMode() and digitalWrite() commands
- Creating your first sketch
- Writing code to turn LEDs on and off
- Wiring a pushbutton to Arduino
- Activating an LED with a pushbutton
Skill Level Beginner
Learning Arduino: Pulse Width Modulationwith Rae Hoyt1h 16m Intermediate
Learning Arduino: Interfacing with Hardwarewith Zahraa Khalil1h 40m Intermediate
1. Introduction to Arduino
2. Creating an Arduino Program
3. Interface with Ouptut: LED
4. Interface with Input: Pushbutton
- Mark as unwatched
- Mark all as unwatched
Are you sure you want to mark all the videos in this course as unwatched?
This will not affect your course history, your reports, or your certificates of completion for this course.Cancel
Take notes with your new membership!
Type in the entry box, then click Enter to save your note.
1:30Press on any video thumbnail to jump immediately to the timecode shown.
Notes are saved with you account but can also be exported as plain text, MS Word, PDF, Google Doc, or Evernote.